Basic Info.
Model NO.
KDEQ-01-314
Automatic Production Line
Assembly
Certification
ISO
Flexible Production
Intelligent Manufacturing
Rhythm
Flow Production Line
Production Scope
Product Line
Transport Package
Plywood Case
Specification
18000mm*800mm*800mm
Trademark
Kiande
Origin
China
HS Code
847981900
Production Capacity
6 Sets Two Months
Product Description
Busbar semi-automatic reversal assembly line, busduct production equipment
Semi-automatic assembly line is composed of three parts, pre-assembly station, automatic reversal station and accessory assembly station.
Pre-assembly station: Operators will pre-assemble and fix busbar main parts by the fixtures and transfer the busbar to the automatic reversal station manually.
Automatic reversal station: When busbar arrives in the reversal station, operator shall fix the busbar by clamp and start riveting on one side. After one side is done, rotators will be reversed 180 degrees for other side's riveting.
Accessory assembly station: After busbar is riveted, operator will assemble the busbar accessories at this station.
Advantages:
1. The semi-automatic busbar production line can realize automatic clamping from left to right and down to up which is convenient for drilling and riveting.
2. The production line is flexibly compatible,suitable for busbar with width 74.5mm-350mm.
3. The electrical control system can clamp at the same time or separately.
4. The semi-automatic busbar assembly line is a cost-effictive production line and more stable which can decrease the NG rate and labour cost and increase the working efficiency.
5. The clamping is powered by air compressor 5-8MPA, which only comsumes the air when operation and is more environment-friendly comparing with the electrical comsumption of oil pressure.
Specification:
Semi-automatic assembly line is composed of three parts, pre-assembly station, automatic reversal station and accessory assembly station.
Pre-assembly station: Operators will pre-assemble and fix busbar main parts by the fixtures and transfer the busbar to the automatic reversal station manually.
Automatic reversal station: When busbar arrives in the reversal station, operator shall fix the busbar by clamp and start riveting on one side. After one side is done, rotators will be reversed 180 degrees for other side's riveting.
Accessory assembly station: After busbar is riveted, operator will assemble the busbar accessories at this station.
Advantages:
1. The semi-automatic busbar production line can realize automatic clamping from left to right and down to up which is convenient for drilling and riveting.
2. The production line is flexibly compatible,suitable for busbar with width 74.5mm-350mm.
3. The electrical control system can clamp at the same time or separately.
4. The semi-automatic busbar assembly line is a cost-effictive production line and more stable which can decrease the NG rate and labour cost and increase the working efficiency.
5. The clamping is powered by air compressor 5-8MPA, which only comsumes the air when operation and is more environment-friendly comparing with the electrical comsumption of oil pressure.
Specification:
| Busbar structure | Four-piece | Remark |
| Busbar height | H=113~650mm | |
| Busbar length | 1.2~6m | |
| Connection structure | Riveting without hole | |
| Nos Of riveting machine | More than 1 set | |
| Housing dimension | L15~20m*3m | |
| Control mode | Manual riveting, automatic reversal | |
| Nos of swing-table | 2~6 pieces | |
| Nos of up-down clamping fixtures | 3~4 pieces | |
| Voltage | 380/400V AC 50/60Hz | |
| Power | 5kW | |
| Air source | 0.6MPa |
